A/D Conversion Enable/Disable (Address "0")

A/D Conversion Enable/Disable (Address "0")

Address		Function	R/W
Hex	Dec
0H	0	A/D Conversion Enable/Disable	R

Buffer offset "0" stores the information whether to perform A/D conversion in each channel.
To validate the A/D Conversion Enable/Disable settings, Y02 should be turned ON then OFF.

The default value of all channel is "0".

Bits
15	14	13	12	11	10	09	08	07	06	05	04	03	02	01	00
CH16	CH15	CH14	CH13	CH12	CH11	CH10	CH9	CH8	CH7	CH6	CH5	CH4	CH3	CH2	CH1

1 : Enable, 0 : Disable

In case of 8-channel module, B8~B15(CH.9 ~ CH.16) are not used.

If the channel is set to "0" (Disable), the channel does not perform A/D Conversion.
(Example) If channel 2, 4, 6, 7 uses A/D Conversion, the value H006A (Decimal: 106) is stored in the buffer offset "0".

Bits
15	14	13	12	11	10	09	08	07	06	05	04	03	02	01	00
CH16	CH15	CH14	CH13	CH12	CH11	CH10	CH9	CH8	CH7	CH6	CH5	CH4	CH3	CH2	CH1
0	0	0	0	0	0	0	0	0	1	1	0	1	0	1	0
0				0				6				A