Pulse Per 1 Cycle/Rotation

Pulse Per 1 Cycle/Rotation (Offset 15)

In order to measure RPM, this offset value must be configured as a non-zero value. If zero (0) is configured here, PPS will operate in the measurement mode and Error Code (101) is delivered regardless of the "RPM/PPS selection" (Offset 16, Bit #5). In other words, the "Pulse Per 1 Cycle / Rotation" must be set as a non-zero value while the "RPM/PPS selection" flag (Offset 16, Bit #5) is set (turned ON) in order to properly measure the RPM and write the resulting value in the "RPM/PPS Measured Value" (Offset 17, 18) areas. If the "RPM/PPS selection" flag is reset, PPS measurement value will be written.