A/D D/A Module Status
- CIMON (Unlicensed)
You can check firmware version of AD/DA module and Error code at A/D D/A Module Status if you click "Status"
DA Out Enable / DA Out Disable : It is used to make output current value or minimum value
(If power of PLC is turned Off, setting becomes DA Out Disable. Thus Y23 and Y24 should be always on in ladder program. Please check I/O signal Table.)
DA Set Value : adjust current value.
Reset Error : Clear error codes when there is any arror or any digital value out of 0 ~ 16000(-8000 ~ 8000) is inputted.
In order to make DA Out Enable properly, the bit of DA Out Enable/Disable(Buffer memory No.23) must be set 1. If it is DA Out Disable, the minimum value (4mA, -10V, 0V) outs regardless of digital input value. You can see the "Yes" or "No" as Enable / Disable status at the above picture.
Although you setup DA Out Enable, it will become DA Out Disable when power of PLC is turned OFF and ON.