Installation and Wiring
- CIMON (Unlicensed)
Installation environment
Environmental conditions
Install the module in control panel which is water proof and anti-vibration
Install the module where there is no persistent shock and vibration.
Install the module where it is not exposed to direct sun ray
Install this module where there is no condensation due to rapid temperature
Install this module where surrounding temperature is maintained at -10 ~ +65¡É.
Installation procedure
Make sure that residues from machining screw hole or wiring are not inserted into PLC
Install the module where operation is easy to be performed.
Do not install the module in devices with high voltage and same panel.
Keep more than 50 mm of gap from duct and surrounding module.
Put to earth where surrounding noise environment is good.
Cautions for handing
Do not drop it or put strong shock on it.
not separate PCB from case. Otherwise it may cause malfunction.
Make sure that foreign substance such as residue from wiring is not inserted into upper areas of module. If foreign substance is found there, remove it.
Do not mount or dismount module while power is turned on.
Wiring
Terminal 1,2,3 and 4,5,6 receives input signal and Terminal 7,8,9 and 10,11,12 receives output signal.
[ Voltage Input / Output ]
Channel | + Terminal |
|
AD Ch 1 | Terminal 1 | Terminal 3 |
AD Ch 2 | Terminal 4 | Terminal 6 |
DA Ch 1 | Terminal 7 | Terminal 9 |
DA Ch 2 | Terminal 10 | Terminal 12 |
24V External | Connection : bottom of module | |
[ Current Input / Output ]
Channel | + Terminal |
| Action |
AD Ch 1 | Terminal 1 | Terminal 3 | Connect 1-2 |
AD Ch 2 | Terminal 4 | Terminal 6 | Connect 4-5 |
DA Ch 1 | Terminal 8 | Terminal 9 |
|
DA Ch 2 | Terminal 11 | Terminal 12 |
|
24V External | Connection : bottom of module | ||
[Wiring Input Method]
|
|
|---|
[Wiring Output Method]
|
|
|---|