DA Channel Setting

If you double click one of DA channel or click "Setup", "DA Channel Setup" window pops up.

Digital Value Range : 0 ~ 16000, - 8000 ~ 8000
Output Type : 4 ~ 20mA, 0 ~ 20mA, 1 ~ 5V, 0 ~ 5V, -10 ~ 10V, 0 ~ 10V
STOP mode output : HOLD, CLEAR, Half Level, Max. Level
Resolution : 14bits (1/16000), 16bits (1/64000)

In order to run CA by set value, click "Write". The message "Set value was written to PLC" is displayed. Set values are recorded at EEPROM. Therefore, conversion is carried out by current set values even power is On/Off. If you click "Read", it reads current set value from DA card.