Control Type

Independent

This control is set when executing only one designated data item of positioning. If a dwell time is designated, the positioning will complete after the designated time expires.
Or if this control is used at the end of positioning data list, this data becomes the end of block data when carrying out block positioning. The positioning will stop after this data.

Continuous

This control is used when a series of positioning control is needed. The last position data of this chain must be designated as independent control type to finish the positioning. The machine always automatically decelerates each time the positioning is completed. Acceleration is then carried out after the speed reaches 0 to carry out the next positioning data operation. If a dwell time is designated, the acceleration is carried out after the designated time expires. In operation by continuous positioning control, the next positioning number is automatically executed.