/
Channel Setup - PLCS TC

Channel Setup - PLCS TC

If you double click channel or click "Setup", you can see "Channel Setup" as below picture.

 

image-20240326-054124.png

 

TC Type : K, J, E, T, R, S, B, N
Digital value range : -192~16191, -8192~8191, 0~16000, -8000~8000
Digital Filter : 0~70%
Average : 1~255초

After setting, click "OK" to save setting value.

 

image-20240326-054127.png

 

If you select whole channels by mouse as below and click "Setup", you can set all channels at once

 

 

In order to run TC module with setting value, click "Write"
"Set value is written to PLC." Appears on the screen.
Set values are recorded at EEPROM. Therefore, conversion is carried out by current set values even power is On/Off
If you click "Read", CICON reads setting value from TC module.

Related content

Channel Setup
Channel Setup
More like this
Setting up Channels - TC Module
Setting up Channels - TC Module
More like this
DA Module
DA Module
More like this
TC Module - Special Module Setting
TC Module - Special Module Setting
More like this
TC conversion Enable/Disable setting(Buffer memory address "0")
TC conversion Enable/Disable setting(Buffer memory address "0")
More like this
DA Channel Setting
DA Channel Setting
More like this