Reserved I/O

Reserved I/O let you organize I/O points to match your modules which will be installed in Base.

It is easier to detect wrong module installation and to replace module without I/O change.

The Reserved I/O supports only CM1 series.

Click Local : Detects Automatically

Open

From the Base Type pull-down menu, choose the Base number.

Open

Click the module and choose I/O type and points.

Occupied 01 : I/O 16points

Occupide 02 : I/O 32points

 Click OK.

    You can find out I/O point for each slot you just made.

In order to reserve I/O points for expansion Base, click Enable and choose the number of expansion base at the PLC Parameter.

 Double-click Reserved IO and click Expansion#01 tab

   Choose Base type and write starting I/O address

   The starting I/O address must be different with other expansion base or Local

You can also use I/O SCAN to find out slot information automatically.

Click the module and choose I/O type and points.

    If module is not Digital I/O module, choose the Function Module.

Click Online → Download then you can find out expansion I/O address starts from 200.

How to read I/O points

I/O address :0000~0100

Slot No.0 : 16points, Occupied 1

Slot No.1 : 16points, Occupied 1

Slot No.2 : 16points, Occupied 1

Slot No.3 : 16points, Occupied 1

Slot No.4 : 16points, Occupied 1

Slot No.5 : 16points, Occupied 1

Slot No.6 : 64points, Occupied 4

Slot No.7 : 16points, Occupied 1

If Local base use 0000~0100, Expansion base needs to use from 0110.