Installation(XPnE)

Owned by 주익균(Ik Kyun Joo)
Last updated: Dec 09, 2024
1 min read

  1. When installing the module, mount the upper side of the module at the top of the base first.

And push down the bottom side of the module until it clicks.

  1. Then, tighten the screw at the bottom of the module to avoid falling out of the slot in case of vibration or shock.

  1. Place the power module on the leftmost slot of the base, and then place the CPU module on the next slot. The position of the power module and CPU module are marked on the base. If you place modules in the wrong slot, the module will not be fully attached.

  1. Supporting Modules are as follows:

  1. Power Module: CM1-SPA, CM1-SPC, CM1-SP2B, CM1-SPW

  • Power redundancy system: Only CM1-SPR (Power module), CM1-XP1R (CPU Module)

  1. Base Modules: CM1-BS03A/04A/05A/08A/10A/12A

  • Power redundancy system: Only CM1-BS05S/08S/10S

 

image-20241209-064148.png