/
Installation(CM1-Redundancy)

Installation(CM1-Redundancy)

  1. When installing the module, mount the upper side of the module at the top of the base first.

And push down the bottom side of the module until it clicks.

  1. Then, tighten the screw at the bottom of the module to avoid falling out of the slot in case of vibration or shock.

  2. Place power module on the leftmost slot of the base, and then place the CPU module on the next slot. The position of Power module (PWR#A, PWR#B), CPU module and PWR monitor module are marked on the base. If you place modules in the wrong slot, the module will not be fully attached.

  3. Supporting Modules are as follows:

  • Power Module: CM1-SPR

  • CPU Module: CM1-XP1R/S

  • Power Monitor Modules: CM1-RPW

  • Base Modules: CM1-BS05S/08S/10S

  • Redundancy Communication Modules: CM1-RC10A

  • Redundancy Interface Modules: CM1-RM01B

  1. Redundancy Communication and Interface modules must be placed at extension module slots.

 

image-20241217-065118.png

 

Related content

Redundancy Module Configuration(CM1 Redundancy)
Redundancy Module Configuration(CM1 Redundancy)
More like this
Required items for Redundancy(CM1 Redundancy)
Required items for Redundancy(CM1 Redundancy)
More like this
Installing and Testing - Ethernet Module
Installing and Testing - Ethernet Module
More like this
Redundant System
Redundant System
More like this
Installation and Wiring
Installation and Wiring
More like this
Installation (CM-eXT2-15W)
Installation (CM-eXT2-15W)
More like this