Performance Specifications
- CIMON (Unlicensed)
The following describes the performance specifications of CIMON PLC-S built-in High Speed Counter.
Item | Specification | ||
Count Input Signal | Phase | Phase A, Phase B | |
Type | Voltage Input (Open Collector) | ||
Level | DC 12V~24V | ||
Max. Counting Speed | 16Kpps (In case of 2 Phase 2 Multiplication: 4Kpps) | ||
Channel | 2 Phase | 2 Channels | 16Kpps |
Counting Range | Signed 32 Bit (-2,147,483,648 ~ 2,147,483,647) | ||
Count Mode | Linear Count (Carry/Borrow Flag occurs when out of the counting range) | ||
Ring Count (Repeated count within a set range from 0 to positive integer) | |||
Input Signal Mode (configurable) | 1 Phase 2 Multiplication, Low Active Input (Pulse/Direction) | ||
1 Phase 2 Multiplication, High Active Input (Pulse/Direction) | |||
2 Phase 2 Multiplication Input | |||
2 Phase 4 Multiplication Input | |||
Signal Type | Voltage | ||
Up/Down Selection | 1 Phase Input | Direction + Pulse Signal | |
2 Phase Input | Automatically detected by the phase difference | ||
Multiplication Function | 1 Phase Input | 2 Multiplication (fixed) | |
2 Phase Input | 2 or 4 Multiplication (select the program) | ||
Control Input | Signal | Preset Command Input | |
Level | DC 24V Input Type | ||
Type | Voltage | ||
External Output | Output Point | 1 Point / 1 Channel | |
Mode | Single Compare (>, >=, =, =<, <) or Section Compare (Include or Exclude) | ||
Type | Relay or Open Collector Output (Sink): Dependable on CPU Type | ||
Count Enable | Can be configured in Program (Count only in enabled state) | ||
Preset Function | External Input Signal or Program | ||
Other Functions | Latch Count Pulse Speed Measuring (time unit configurable) RPM / PPS Measuring | ||