/
Channel Setup
Channel Setup
If you double click channel or click "Setup", you can see "Channel Setup" as below picture
RTD Type : PT100, JPT100, PT1000, NI1000
Digital Value Range : -192~16191, -8192~8191, 0~16000, -8000~8000
Digital Filter : 0~70%
Average: 1~255 sec.
After setting, click "OK" to save setting value.
If you select whole channels by mouse as below and click "Setup", you can set all channels at once
In order to run RTD module with setting value, click "Write"
"Set value is written to PLC." appears on the screen.
Set values are recorded at EEPROM. Therefore, conversion is carried out by current set values even power is On/Off
If you click "Read", CICON reads setting value from RTD module.
, multiple selections available,
Related content
Setting up Channels
Setting up Channels
More like this
RTD conversion Enable/Disable setting(Buffer memory address "0")
RTD conversion Enable/Disable setting(Buffer memory address "0")
More like this
Channel Setup - PLCS TC
Channel Setup - PLCS TC
More like this
Designate RTD type (Buffer memory address "9")
Designate RTD type (Buffer memory address "9")
More like this
RTD Module - Special Module Setting
RTD Module - Special Module Setting
More like this
Enabling/Disabling to RTD-Convert ("0")
Enabling/Disabling to RTD-Convert ("0")
More like this