MITSUBISHI MELSEC A Loader (Programming Port)

To create a new device, select [Tools] → [I/O Devices] or click the icon in the toolbar. The following picture shows the first step in creating a new device:

Open

I/O Device Name: Give a device name. This name will be used in the tag database, accompanied by the ‘Station Name’.

After selecting the [Ok] button in the previous step, the ‘Serial Communication Configuration’ dialog box will appear as shown in the following picture:

Open

In this window, set the ‘Device Type’ to ‘MITSUBISHI MELSEC A Loader’ and configure the remaining serial communication parameters. Make sure the following parameters match those shown in the image above, as these values are required for this protocol to work correctly.

Baud Rate: 9,600

Parity: Odd

Data Bits: 8 Bits

Stop Bits: 1 Bit

Comm. Type: RS232

See the Communication Configuration section for more information about the remaining parameters.

Move to the [Station] tab of the ‘Serial Communication Configuration’ dialog box. In this dialog box, connected PLC stations can be configured and registered to the Xpanel.

Each station can be configured using the following parameters:

Station Name: Give a name to the PLC. This name will be used in the database window, accompanied by the ‘Device Name’.

Station Type: Choose the type of connected PLC CPU. One of the three CPUs can be chosen (AnS, AnA, AnU).

Network ID: N/A

Station No: N/A

See the Communication Configuration section for more information about the remaining parameters.

Notation (Base)

Format

Example

10 (decimal)

[Symbol][Address in decimal format]

D0012

16 (hexadecimal)

[Symbol][Address in hexadecimal format]

X01FC