| This section gives an illustrative example of connecting an I/O device to Xpanel. Settings may differ based on your project’s configuration. |
Exercise: Connecting to a
...
POWERTRAN PLC through Ethernet
(1) I/O Device Configuration
...
a) In CICON, create the program shown below. The program saves a random number at D0 while M00 is on.
...
b) In the CICON project tree, go to [Parameter] – [PLC Parameter] and double-click it. In the ethernet tab, set the IP address for the PLC. If the PLC and Xpanel are on the same local network, then the subnet mask and gateway should match. When you are finished, press [OK].
...