...
In the [Xpanel Config] window, select [Modbus] to bring up the [Modbus Channel Setting] window as shown below.
...
In the case of MODBUS TCP, the window will appear with all fields disabled. The , and the Xpanel device will communicate using the Ethernet IP address which is configured in the Ethernet Loader and Comm. Config. menus.
...
After configuring Xpanel as a Modbus Slave in XpanelDesigner, you can connect to a CIMON-PLC which acts as a Modbus Master. Configuration for the PLC is performed in the CICON software package. The following is an example of a PLC-S configuration for this type of communication.
CICON Configuration
a) Create In CICON, create a project that uses a PLC-S CPU. Press [File] – [New Program] and select MODBUS/TCP Master. If you are using serial communication, select MOBUS/RTU Master.
...
d) After adding a communication block, select [Tool] – [PLC Parameter], then go to the [Modbus] tab to set the Modbus device addresses for communication. Then go
...
3) Go to the [Ethernet] tab to enter the IP configuration for the PLC. If you are using a serial communication, go to the [Channel 1] or [Channel 2] tab instead.
...