Versions Compared

Version Old Version 6 New Version 7
Changes made by

Christian Heilman (Unlicensed)

Christian Heilman (Unlicensed)

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  1. If the Settings dialog box is not already open, then touch the corners of the Xpanel screen in the sequence shown below: bottom-left -> bottom-right -> top-right. The Settings window will appear.

  2. Select [Exit]. This will stop the Xpanel runtime and take you to the [CONTROL CENTER] window.

  3. Navigate to the IP settings by clicking [Settings] > [IP Config]. Set the user’s IP address(es) for the Xpanel device in either LAN 1 and/or LAN 2. After the user’s IP information is set, scroll to the bottom and click [Apply and Save]. If the subnet mask and/or gateway are different from those of the PC, then change them to match the PC.

    Image RemovedImage Added

    Image RemovedImage Added

 

(blue star)

  • The Subnet Mask and Gateway fields should be configured to match those of the PC. These can be found using the ‘ipconfig’ command.

  • Duplicate IP addresses are not allowed. Make sure the IP address you choose is not being used by another device on the network.

  • The Xpanel IP address must be on the same local network as the PC. If the subnet mask is set to 255.255.255.0, this means the first 3 values of the IP address must match those of the default gateway. If the subnet mask is set to 255.255.0.0, then the first 2 values must match, and so on.

...

  1. Run CIMON Canvas and open a project to be downloaded, or proceed to the next step if you are uploading to the PC.

  2. Go to [Tools] > [Deployment Panel] and choose which Xpanel you will be using by checking the box on the left-hand side. If the [Status] of the Xpanel is OFFLINE, the user will not be able to download/upload a project.

    Image RemovedImage Added

  3. The user will receive a warning message confirming they will install the currently loaded project on CIMON Canvas to the selected Xpanel. If the user is certain, click [Ok].

...