Page Comparison

Create a new device

To create a new device, select 'Tools' → 'I/O device' in the menu or click on the icon in the toolbar. The “I/O device configuration” dialog box will appear as shown below. Click [New Device]. From the “I/O Device Selection” dialog box, select a device name and device type as shown below:

I/O Device Name: Set a device name. This name will be used in the tag configuration window of the Database, accompanied by the ‘Station Name’.

Select a device type

After selecting the ‘OK’ button in the previous step, the ‘Serial Communication Configuration’ dialog box will appear as shown in following picture.

In this window, select ‘PGuard gateway’ as the device type, then configure the remaining communication parameters appropriately. These parameters must be matched with the PGuard device.

Create a station

Move to the ‘Station’ tab of the ‘Serial Communication Configuration’ dialog box and click the [Add Station] button. The ‘Station’ dialog box will then appear. Configure the options as shown below, then click the “OK” button.

• Note: Only register 1 station for the ‘PGuard gateway’ driver. Registering more than 1 station may result in a malfunction.

Station Name: Give a name to the PLC. This name will be used to assign device tag names in the Database, accompanied by the 'Device Name'.

Station Type: Choose 'SGW'.(No other type can be slected)

Network ID: N/A

Station No: Write the designated PLC station No.

16Bit Data Swap: N/A

32Bit Data Swap: N/A

Using checksum: N/A

Comm. Error Message Pop Up: When this item is checked, Xpanel displays a communication error message box for every Rx and Tx error. Otherwise (unchecked), Xpanel does not display a message for communication errors. This message box will close automatically after a few seconds.